Filter
Top Products
Advanced Configuration and Management Guide
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-write access.
2. Click on the plus sign next to Configure in the tree view to expand the list of configuration options.
3. Click on the plus sign next to AppleTalk in the tree view to expand the list of AppleTalk option links.
4. Click on the General
link to display the AppleTalk configuration panel.
5. Enter a new ARP retransmit count from 1 – 10 in the ARP Retransmit Count field. For this example, enter 8.
6. Click the Apply button to apply the change to the device’s running-config file.
7. Select the Save
link at the bottom of the dialog, then select Yes when prompted to save the configuration
change to the startup-config file on the device’s flash memory
NOTE: You also can access the dialog for saving configuration changes by clicking on Command in the tree
view, then clicking on
Save to Flash.
AppleTalk ARP Retransmit Interval
You can modify the interval between the transmission of ARP packets. Possible values are from 1 – 120 seconds.
The default is 1 second.
EXAMPLE:
To modify the ARP retransmission interval from the default value (1) to 15 seconds, use one of the following
methods.
USING THE CLI
HP9300(config)# appletalk arp retransmit-interval 15
Syntax: appletalk arp retransmit-interval <1-120>
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-write access.
2. Click on the plus sign next to Configure in the tree view to expand the list of configuration options.
3. Click on the plus sign next to AppleTalk in the tree view to expand the list of AppleTalk option links.
4. Click on the General
link to display the AppleTalk configuration panel.
5. Enter a new AppleTalk ARP Retransmit Interval from 1 – 120 in the ARP Retransmit Interval field. For this
example, enter 15.
6. Click the Apply button to apply the change to the device’s running-config file.
7. Select the Save link at the bottom of the dialog, then select Yes when prompted to save the configuration
change to the startup-config file on the device’s flash memory.
AppleTalk Glean Packets
When you enable the glean packet parameter on an AppleTalk router, the router tries to learn the MAC address
from the packet instead of sending out an ARP request. The glean packets parameter is disabled by default.
EXAMPLE:
To enable glean packets, use one of the following methods.
USING THE CLI
HP9300(config)# appletalk glean-packets
Syntax: appletalk glean-packets
15 - 18