Filter
Top Products
Advanced Configuration and Management Guide
Table 10.5: BGP4 Route Summary Information for a Neighbor (Continued)
Peer Out of Memory Count for Statistics for the times the routing switch has run out of BGP4 memory
for the neighbor during the current BGP4 session.
• Receiving Update Messages – The number of times UPDATE
messages were discarded because there was no memory for
attribute entries.
• Accepting Routes(NLRI) – The number of NLRIs discarded
because there was no memory for NLRI entries. This count is not
included in the Receiving Update Messages count.
• Attributes – The number of times there was no memory for BGP4
attribute entries.
• Outbound Routes(RIB-out) – The number of times there was no
memory to place a “best” route into the neighbor's route
information base (Adj-RIB-Out) for routes to be advertised.
This Field... Displays...
USING THE WEB MANAGEMENT INTERFACE
You cannot display summary neighbor information using the Web management interface.
Displaying BGP4 Neighbor Information
You can display configuration information and statistic for the router’s BGP4 neighbors using either of the
following methods.
USING THE CLI
To view BGP4 neighbor information for the router, enter the following command:
HP9300# show ip bgp neighbors 192.168.4.211
IP Address AS# EBGP/IBGP RouterID PeerGroup
1 192.168.4.211 65001 EBGP 8.8.8.8 None
State Time KeepAlive HoldTime RefreshCapability
ESTABLISHED 0h1m5s 60 180 Received
SendCommunity NextHopSelf DefaultOriginate ReflectorClient UpdateSource
No No No No None
Open Update KeepAlive Notification Refresh-Req
Message Sent: 2 6 2 1 1
Message Received: 2 15 4 0 1
Last Connection Reset Reason:User Reset Peer Session
Notification Sent: Unspecified
Notification Received: Unspecified
TCP Connection state: ESTABLISHED
Local host: 192.168.2.102, Local Port: 8118
Remote host: 192.168.4.211, Remote Port: 179
ISentSeq: 2752793 SendNext: 2753085 TotUnAck: 0
TotSent: 292 ReTrans: 0 UnAckSeq: 2753085
IRcvSeq: 4010160420 RcvNext: 4010161139 SendWnd: 16093
TotalRcv: 719 DupliRcv: 0 RcvWnd: 16384
SendQue: 0 RcvQue: 0 CngstWnd: 1181
This example shows how to display information for a specific neighbor, by specifying the neighbor’s IP address
with the command. None of the other display options are used; thus, all of the information is displayed for the
neighbor. The number in the far left column indicates the neighbor for which information is displayed. When you
list information for multiple neighbors, this number makes the display easier to read.
10 - 90