Filter
Top Products
Advanced Configuration and Management Guide
Table 12.4: Web Display of VRRP Detailed Information (Continued)
Mode Indicates whether the routing switch is the Owner or a Backup for the
VRID.
Note: The mode applies only to VRRP. l routing switches
configured for VRRPE are Backups.
Backup – Priority The device’s preferability for becoming the Master for the VRID.
During negotiation, the router with the highest priority becomes the
Master.
If two or more devices are tied with the highest priority, the Backup
interface with the highest IP address becomes the active router for the
VRID.
Backup – Dead Intv The number of seconds a Backup waits for a Hello message from the
Master for the VRID before determining that the Master is no longer
active.
If the Master does not send a Hello message before the dead interval
expires, the Backups negotiate (compare priorities) to select a new
Master for the VRID.
Backup – Preempt The state of the Backup preempt mode. e Backup preempt mode
prevents a Backup with a higher VRRP priority from taking control of
the VRID from another Backup that has a lower priority but has
already assumed control of the VRID.
Track – Priority A VRRP priority value assigned to the tracked port(s). f a tracked
port’s link goes down, the VRID port’s priority is reduced by the
amount of the tracked port’s priority.
Track – Vif List The virtual interfaces that the VRID’s interface is tracking. If the link
for a tracked interface goes down, the VRRP priority of the VRID
interface is changed, causing the devices to renegotiate for Master.
Track – Port List The physical ports that the VRID’s interface is tracking. If the link for a
tracked port goes down, the VRRP priority of the VRID interface is
changed, causing the devices to renegotiate for Master.
This Field... Displays...
Al
Th
I
Displaying Statistics
To display VRRP or VRRPE statistics, use either of the following methods.
USING THE CLI
To display statistics, enter a command such as the following at any level of the CLI:
HP9300(config-if-e1000-1/5-vrid-1)# show ip vrrp stat
Interface ethernet 1/5
rxed vrrp header error count = 0
rxed vrrp auth error count = 0
rxed vrrp auth passwd mismatch error count = 0
rxed vrrp vrid not found error count = 0
VRID 1
rxed arp packet drop count = 0
rxed ip packet drop count = 0
12 - 26