Filter
Top Products
8: Device Ports
SLB™ Branch Office Manager User Guide 112
Escape Sequence
The escape character used to get the attention of the SSH
or Telnet client. It is optional, and if not specified, Telnet
and SSH use their default escape character.
For Telnet, the escape character is either a single
character or a two-character sequence consisting of '^'
followed by one character. If the second character is '?', the
DEL character is selected. Otherwise, the second character
is converted to a control character and used as the escape
character.
For SSH, the escape character is a single character.
3. You have the following options:
To add a host to the host list, click the right arrow. The host displays in the
Hosts box.
To remove a host from the host list, select the host in the Hosts box and click the
left arrow.
To give the host a higher precedence, select the host in the Hosts box and click
the up arrow.
To give the host a lower precedence, select the host in the Hosts box and click
the down arrow.
4. Click the Edit Host List button. After the process completes, a link back to the
Device Ports – Settings page displays.
To delete a host list:
1. Select the host list in the Host Lists table.
2. Click the Delete Host List button. After the process completes, a link back to the
Device Ports – Settings page displays.
Host List Commands
The following CLI commands correspond to the web page entries described above.
To configure a prioritized list of hosts to be used for modem dial-in connections:
set hostlist add|edit <Host List Name> [<parameters>]
Parameters:
name <Host List Name> (edit only)
retrycount <1-10>
Default is 3.
auth <enable|disable>