Lantronix 900-510 Switch User Manual


 
11: User Authentication
SLB™ Branch Office Manager User Guide 157
Reboot &
Shutdown
Right to use the CLI or shut down the SLB branch office
manager and then reboot it.
Firmware &
Configuration
Right to upgrade the firmware on the unit and save or restore
a configuration (all settings). Selecting this option
automatically selects Reboot & Shutdown.
Diagnostics &
Reports
Right to obtain diagnostic information and reports about the
unit.
Web Access
Right to access Web Manager.
Device Ports
Right to enter device port settings.
PC Card
Right to enter modem settings for PC cards.
Power Outlets
Right to configure power outlets.
5. Click the Apply button.
Note: You must reboot the unit before your changes will take effect.
RADIUS Commands
These commands for the command line interface correspond to the web page entries
described above.
To configure the SLB branch office manager to use RADIUS to authenticate users
who log in via the Web, SSH, Telnet, or the console port:
set radius <one or more parameters>
Parameters:
accessoutlets <Outlet List>
breakseq <1-10 Chars>
clearports <Port List>
dataports <Port List>
escapeseq <1-10 Chars>
listenports <Port List>
state <enable|disable>
To identify the RADIUS server(s), the text secret, and the number of the TCP port
on the RADIUS server:
set radius server <1|2> host <IP Address or Hostname> secret
<Secret> [port <TCP Port>]
The default port is 1812.
To set the number of seconds after which the connection attempt times out:
set radius timeout <disable|1-30>
May be 1-30 seconds.