Lantronix 900-510 Switch User Manual


 
14: Command Reference
SLB™ Branch Office Manager User Guide 244
xferdatasize <Size In Kbytes to Transfer>
Default is 1 Kbyte.
Description
Tests a device port by transmitting data out the port and verifying that it is received correctly.
A special loopback cable comes with the SLB branch office manager. To test a device port, plug
the cable into the device port and run this command. The command sends the specified Kbytes to
the device port and reports success or failure. The test is performed at 9600 baud. Only an
external test requires a loopback cable.
diag traceroute
Syntax
diag traceroute <IP Address or Hostname>
Description
Displays the route that packets take to get to a network host:
End Device Commands
set command
Syntax
set command <Device Port # or Name or List> <one or more parameters>
Parameters
slp auth login <User Login>
Establishes the authentication information to log into the SLP power manager attached to the
device port.
slp envmon
Displays the environmental status (e.g., temperature and humidity) of the SLP power manager.
slp outletcontrol state <on|off|cyclepower> [outlet <Outlet #>]
Outlet # is 1-8 for SLP8 power manager and 1-16 for SLP16 power manager. The
outletcontrol parameters control individual outlets.
slp outletstate [outlet <Outlet #>]
Shows the state of all outlets or a single outlet.
slp restart
Issues the CLI command the SLP power manager uses to restart itself.
slp system
Displays system information for the SLP power manager.
Description
Sends commands to (or controls) a device connected to an SLB device port over the serial port.
Currently the only type of device supported for this type of interaction is the SLP power manager.