Filter
Top Products
11: User Authentication
SLB™ Branch Office Manager User Guide 164
2. Enter the following:
Enable TACACS+
Displays selected if you enabled this method on the User
Authentication page. If you want to set up this authentication
method but not enable it immediately, clear the checkbox.
You can enable TACACS+ here or on the first User Authentication
page. If you enable TACACS+ here, it automatically displays at
the end of the order of precedence on the User Authentication
page.
TACACS+ Servers
1-3
IP address or host name of up to three TACACS+ servers.
Secret
Shared secret for message encryption between the SLB branch
office manager and the TACACS+ server. Enter an alphanumeric
secret of up to 127 characters.
Encrypt Messages
Select the checkbox to encrypt messages between the SLB
device and the TACACS+ server. Selected by default.
Custom Menu
If custom menus have been created (see the User Guide), you
can assign a default custom menu to TACACS+ users.
Escape Sequence
A single character or a two-character sequence that causes the
SLB branch office manager to leave direct (interactive) mode. (To
leave listen mode, press any key.)
A suggested value is Esc+A (escape key, then uppercase "A"
performed quickly but not simultaneously). You would specify this
value as \x1bA, which is hexadecimal (\x) character 27 (1B)
followed by an A.
This setting allows the user to terminate the connect direct
command on the command line interface when the endpoint of the
command is deviceport, tcp, or udp.
Break
Sequence
A series of 1-10 characters users can enter on the command line
interface to send a break signal to the external device. A
suggested value is Esc+B (escape key, then uppercase “B”
performed quickly but not simultaneously). You would specify this
value as \x1bB, which is hexadecimal (\x) character 27 (1B)
followed by a B.
Data Ports
The ports users are able to monitor and interact with using the
connect direct command. U and L denote the upper and
lower slots of the PC Card.
Listen Port
The ports users are able to monitor using the connect listen
command.
Clear Port Buffers
The ports whose port buffer users may clear using the set
locallog clear command.
Access Outlets
The power outlets users may monitor and configure.
3. In the User Rights section, select the user group to which TACACS+ users will
belong.