Filter
Top Products
Chapter 14 xDSL Profiles Setup
IES-612-51A User’s Guide
136
The following table describes the labels in this screen.
Table 28 IGMP Filter Profile
LABEL DESCRIPTION
Port Profile Click Port Profile to configure port profiles and assign them to individual ports
(see Section 14.1 on page 125).
VC Profile Click VC Profile to open the VC Profile screen where you can configure virtual
channel profiles (see Section 14.5 on page 131).
Alarm Profile Click Alarm Profile to open the Alarm Profile screen where you can configure
limits that trigger an alarm when exceeded (see Section 14.6 on page 133)
Index This is the number of the IGMP filter profile. Click a profile’s index number to
edit the profile. You cannot edit the DEFVAL profile.
Name This name identifies the IGMP filter profile.
Delete Select the Delete check box and click Delete to remove an IGMP filter profile.
You cannot delete the DEFVAL profile.
Name Type a name to identify the IGMP filter profile (you cannot change the name of
the DEFVAL profile). You can use up to 31 ASCII characters; spaces are not
allowed.
Start IP Enter the starting multicast IP address for a range of multicast IP addresses to
which you want this IGMP filter profile to allow access.
End IP Enter the ending multicast IP address for a range of IP addresses to which you
want this IGMP filter profile to allow access.
If you want to add a single multicast IP address, enter it in both the Start IP and
End IP fields.
Add Click Add to save your changes to the IES-612-51A’s volatile memory. The IES-
612-51A loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel Click Cancel to start configuring the screen again.