ZyXEL Communications IES-612-51A Modem User Manual


 
IES-612-51A User’s Guide
235
CHAPTER 35
Static Routing
This chapter shows you how to configure the static routing function.
Static routes tell the IES-612-51A how to forward the IES-612-51A’s own IP traffic when you
configure the TCP/IP parameters manually. This is generally useful for allowing management
of the device from a device with an IP address on a different subnet from that of the device’s
IP address (remote management).
To open this screen, click Routing Protocol, Static Routing.
Figure 118 Static Routing
The following table describes the labels in this screen.
Table 79 Static Routing
LABEL DESCRIPTION
Use this section to create a new static route.
Name Type a name to identify this static route. Use up to 31 ASCII characters. Spaces
and tabs are not allowed.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing
is always based on network number. If you need to specify a route to a single
host, use a subnet mask of 255.255.255.255 in the subnet mask field to force
the network number to be identical to the host ID.
IP Subnet Mask Enter the subnet mask for this destination.
Gateway IP Address Enter the IP address of the gateway. The gateway is an immediate neighbor of
your device that will forward the packet to the destination. The gateway must be
a router on the same segment as your device.