ZyXEL Communications IES-612-51A Modem User Manual


 
Chapter 46 MAC Commands
IES-612-51A User’s Guide
311
46.3.3 MAC Count Disable Command
Syntax:
ras> switch mac count disable <portlist>
where
This command disables the MAC filtering feature on the specified DSL port(s).
The following example turns off the MAC count filter on DSL port 4.
46.3.4 MAC Count Set Command
Syntax:
ras> switch mac count set <portlist> <count>
where
This command sets the limit for how many MAC addresses may be dynamically learned on
the specified DSL port(s).
The following example sets the MAC count filter to allow up to 50 MAC addresses to be
dynamically learned on DSL port 7.
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~10>.
Figure 169 MAC Count Disable Command Example
ras> switch mac count disable 4
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~10>.
<count> =
Set the limit for how many MAC addresses that a port may
dynamically learn. For example, if you are configuring port 2
and you set this field to "5", then only five devices with
dynamically learned MAC addresses may access port 2 at any
one time. A sixth device would have to wait until one of the five
learned MAC addresses ages out.
The valid range is from “1” to “128”.
Figure 170 MAC Count Set Command Example
ras> switch mac count set 7 50