Filter
Top Products
Chapter 31 ACL
IES-612-51A User’s Guide
219
31.4 ACL Profile Map Screen
Use this screen to look at all the ACL profiles and the PVCs to which each one is assigned. To
open this screen, click Advanced Application, ACL, ACL Profile Map.
Profile Name Enter a descriptive name for the ACL profile. The name can be 1-31 printable
ASCII characters long. Spaces are not allowed.
Rule Select which type of rule to use.
Note: The lower the number (1-14), the higher the priority the rule
has.
Provide additional information required for the selected rule. Additional rules
consist of one or more of the following criteria.
ethernet type Enter the 16-bit EtherType value between 0 and 65535.
vlan Enter a VLAN ID between 1 and 4094.
source mac Enter the source MAC address.
dest mac Enter the destination MAC address.
priority Select the IEEE 802.1p priority.
protocol Select the IP protocol used.
protocol type Enter the IP protocol number (between 0 and 255) used.
source ip Enter the source IP address and subnet mask in dotted decimal notation.
dest ip Enter the source IP address and subnet mask in dotted decimal notation.
tos Enter the start and end Type of Service between 0 and 255.
source port Enter the source port or range of source ports.
dest port Enter the destination port or range of destination ports.
Action Select which action(s) the IES-612-51A should follow when the criteria are
satisfied.
rate Enter the maximum bandwidth this traffic is allowed to have.
replaced vlan Enter the VLAN ID that this traffic should use.
replaced priority Select the IEEE 802.1p priority that this traffic should have.
deny Select this if you want the IES-612-51A to reject this kind of traffic.
ACL Profile List
Index This field displays a sequential value. The sequence in this table is not
important. Click this to edit the associated ACL profile in the section above.
ACL Profile This field displays the name of this ACL profile.
Select
Delete
Select the check box in the Select column for an entry, and click Delete to
remove the entry.
Select All Click this to select all entries in the table.
Select None Click this to un-select all entries in the table.
Table 69 ACL Profile Setup (continued)
LABEL DESCRIPTION