Filter
Top Products
Chapter 45 IEEE 802.1Q Tagged VLAN Commands
IES-612-51A User’s Guide
304
45.4.8 Configuring Management VLAN Example
" After the following example configuration, you must connect to the first
Ethernet port through a VLAN aware device that is using the proper VLAN ID
in order to perform management.
By default, the IES-612-51A’s DSL ports are members of the management VLAN (VID 1).
The following procedure shows you how to configure a tagged VLAN that limits management
access to just one Ethernet port.
" Use the console port to configure the IES-612-51A if you misconfigure the
management VLAN and lock yourself out.
1 Use the switch vlan set command to configure a VLAN ID (VID 3 in this example)
for managing the IES-612-51A (the “management” or “CPU” VLAN).
2 Use the
switch vlan1q vlan cpu command to set VID 3 as the management
VLAN.
45.4.9 VLAN Delete Command
Syntax:
ras> switch vlan delete <vlanlist>
where
This command deletes the specified VLAN ID entry from the static VLAN table. The
following example deletes entry 2 in the static VLAN table.
Figure 157 CPU VLAN Configuration and Activation Example
ras> switch vlan set 3 enet1:FT
Figure 158 Deleting Default VLAN Example
ras> switch vlan cpu set 3
<vlanlist> =
You can specify a single VID: <1>, all VIDs: <*>, a list of
VIDs: <1,3>, you can also include a range of VIDs:
<1,5,6~10>.
Figure 159 VLAN Delete Command Example
ras> switch vlan delete 2