Filter
Top Products
Chapter 52 ADSL Commands
IES-612-51A User’s Guide
353
This command displays or sets masks for downstream carrier tones from 256 to 511 on the
specified ADSL2+ port(s). Use this command to have the system not use a DSL line’s tones
that are known to have a high noise level.
The following example disables downstream carrier tone 307 for ADSL2+ port 5.
The following example disables downstream carrier tones 304 to 307 for ADSL2+ port 5.
The following example displays the results.
52.1.16 PMM Parameters Command
Syntax:
ras> adsl pmm param <portlist> [<l0time> <l2time> <l2atpr> <l2atprt>]
[<max_l2rate> <min_l2rate> <l0tol2_rate>]
where
Figure 230 DSL Port Downstream Carrier1 Command Example 1
ras> adsl dscarrier1 5 0 00001000 0 0 0 0 0 0
Figure 231 DSL Port Downstream Carrier1 Command Example 2
ras> adsl dscarrier1 5 0 0000f000 0 0 0 0 0 0
Figure 232 DSL Port Downstream Carrier1 Command Display Example
ras> adsl dscarrier1 5
ds carrier
port m0 m1 m2 m3 m4 m5 m6 m7
---- |--------|--------|--------|--------|--------|--------|--------|-----
---|
5 00000000 000F0000 00000000 00000000 00000000 00000000 00000000
00000000
Tone:
m0:256-287, m1:288-319, m2:320-351, m3:352-383
m4:384-415, m5:416-447, m6:448-479, m7:480-511
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*>
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
<l0time> =
Set the minimum time in seconds (10~65535) that the DSL
line must stay in L0 power mode before changing to the L2
power mode.
<l2time> =
Set minimum time in seconds (10~65535) that the DSL line
must stay in the L2 power mode before reducing the power
again in the L2 power mode.