Filter
Top Products
Chapter 53 Virtual Channel Management Commands
IES-612-51A User’s Guide
397
This command sets the second VLAN tag to add to the packets from the PVC.
The following example adds VLAN tag
100 to traffic using the DEFVAL ATM profile on PVC
(
1/33) on port 2.
Figure 287 TLS PVC Set Command Example
53.9.3 TLS PVC Show Command
Syntax:
ras> adsl tlspvc show <portlist> [<vpi> <vci>]
where
This command displays the TLS settings for the specified port(s) or PVC(s). The following
example shows the TLS settings on port 2.
Figure 288 TLS PVC Show Command Example
<vci> =
The VCI of the TLS PVC.
<DS vcprofile =
Assign a VC profile to use for this channel’s downstream
traffic shaping.
[,US
vcprofile]>
=
Assign a VC profile to use for policing this channel’s
upstream traffic. The IES-612-51A does not perform
upstream traffic policing if you do not specify an upstream
VC profile.
<pvid> =
1 – 4094; the (second) VLAN Identifier to add to Ethernet
frames that the system routes using this PVC.
<priority> =
Set the IEEE 802.1p priority (0~7) to add to the traffic that
uses this PVC.
ras> adsl tlspvc set 2 1 33 DEFVAL 100 0
<portlist> =
The port number of the TLS PVC. You can specify a single
DSL port <1>, all DSL ports <*> or a list of DSL ports
<1,3,5>. You can also include a range of ports <1,5,6~10>.
<vpi> =
The VPI of the TLS PVC.
<vci> =
The VCI of the TLS PVC.
ras> adsl tlspvc show 2
port vpi vci pvid pri DS/US vcprofile
---- --- ----- ----- --- ----------------------------------
2 1 33 100 0 DEFVAL