Chapter 53 Virtual Channel Management Commands
IES-612-51A User’s Guide
391
where
This command configures how long the device stores the IP addresses of CPE devices using
2684 routed mode in the Address Resolution Protocol table.
The following example sets the device to store the IP addresses 2684 routed mode gateways in
the Address Resolution Protocol table for 500 seconds.
53.7.12 RPVC ARP Agingtime Show Command
Syntax:
ras> adsl rpvc arp agingtime show
This command displays how long the device stores the IP addresses of 2684 routed mode
gateways in the Address Resolution Protocol table.
The following is an example.
53.7.13 RPVC ARP Show Command
Syntax:
ras> adsl rpvc arp show
This command
displays how long the device stores the IP addresses of 2684 routed mode
gateways in the Address Resolution Protocol table.
The following is an example.
53.7.14 RPVC ARP Flush Command
Syntax:
ras> adsl rpvc arp flush
<sec> =
The number of seconds (10~10000) the device is to keep the
Address Resolution Protocol table’s entries of IP addresses
of 2684 routed mode gateways. Use 0 to disable the aging
time.
Figure 280 RPVC ARP Agingtime Command Example
ras> adsl rpvc arp agingtime set 500
Figure 281 RPVC ARP Agingtime Show Command Example
ras> adsl rpvc arp agingtime show
rpvc aging time (sec): 500
Figure 282 RPVC ARP Agingtime Show Command Example
ras> adsl rpvc arp show
gateway ip vid mac
--------------- ---- -----------------
192.168.10.102 1 00:0d:9d:d9:43:3b
