Filter
Top Products
Chapter 53 Virtual Channel Management Commands
IES-612-51A User’s Guide
392
This command clears the IP addresses of 2684 routed mode gateways from the Address
Resolution Protocol table.
53.8 PPPoA to PPPoE (PAE) Commands
You can use these commands to create PVCs for PAE translation.
53.8.1 PAE PVC Delete Command
Syntax:
ras> adsl paepvc delete <portlist> <vpi> <vci>
where
This command removes a PAE PVC.
53.8.2 PAE PVC Set Command
Syntax:
ras> adsl paepvc set <portlist> <vpi> <vci> <DS vcprofile[,US vcprofile]>
<pvid> <priority> [acname <acname>] [srvcname <srvcname>] [hellotime
<hellotime>]
where
<portlist> =
The port number of the PAE PVC. You can specify a single
DSL port <1>, all DSL ports <*> or a list of DSL ports
<1,3,5>. You can also include a range of ports <1,5,6~10>.
<vpi> =
The VPI of the PAE PVC.
<vci> =
The VCI of the PAE PVC.
<portlist> =
The port number of the PAE PVC. You can specify a single
DSL port <1>, all DSL ports <*> or a list of DSL ports
<1,3,5>. You can also include a range of ports <1,5,6~10>.
<vpi> =
The VPI of the PAE PVC.
<vci> =
The VCI of the PAE PVC.
<DS vcprofile =
Assign a VC profile to use for this channel’s downstream
traffic shaping.
[,US
vcprofile]>
=
Assign a VC profile to use for policing this channel’s
upstream traffic. The IES-612-51A does not perform
upstream traffic policing if you do not specify an upstream
VC profile.
<pvid> =
1 – 4094; the VLAN Identifier to add to Ethernet frames
that the system routes using this PVC.
<priority> =
Set the IEEE 802.1p priority (0~7) to add to the traffic that
uses this PVC.