Filter
Top Products
Chapter 52 ADSL Commands
IES-612-51A User’s Guide
345
The following example displays the DSL DEFVAL profile.
52.1.5 DSL Port Profile Set Command
Syntax:
ras> adsl profile set <profile> <fast|interleave[=<up delay>,<down delay>]>
<up max rate> <down max rate>
[<up target margin> <up min margin> <up max margin> <up min rate>
<down target margin> <down min margin> <down max margin> <down min rate>
<up down-shift margin> <up up-shift margin>
<down down-shift margin> <down up-shift margin>]
where
Figure 215 DSL Profile Show Command Example
ras> adsl profile show DEFVAL
01. DEFVAL latency mode: interleave
up stream down stream
--------- -----------
max rate (kbps): 512 2048
min rate (kbps): 32 32
latency delay (ms): 4 4
max margin (db): 31 31
min margin (db): 0 0
target margin (db): 6 6
up shift margin(db): 9 9
down shift margin(db): 3 3
<profile> =
The descriptive name for the profile.
<fast|interleav
e[=<up
delay>,<down
delay>]>
=
The latency mode. With interleave, you must also define the
upstream and downstream delay (1-255 ms). It is
recommended that you configure the same delay for both
upstream and downstream.
<up max rate> =
The maximum DSL upstream transmission rate (64-4096
Kbps).
<down max rate> =
The maximum DSL downstream transmission rate (64-
32000 Kbps).
<up target
margin>
=
The target DSL upstream signal/noise margin (0-31db).
<up min margin> =
The minimum acceptable DSL upstream signal/noise
margin (0-31db).
<up max margin> =
The maximum acceptable DSL upstream signal/noise
margin (0-31db).
<up min rate> =
The minimum DSL upstream transmission rate (32-4096
Kbps).
<down target
margin>
=
The target DSL downstream signal/noise margin (0-31db).
<down min
margin>
=
The minimum acceptable DSL downstream signal/noise
margin (0-31db).