Filter
Top Products
Chapter 52 ADSL Commands
IES-612-51A User’s Guide
347
This next example creates a similar premium profile (named goldi), except it sets an
interleave delay of 16 ms for both upstream and downstream traffic.
After you create a DSL profile, you can assign it to any of the DSL ports on the IES-612-51A.
52.1.6 DSL Port Profile Delete Command
Syntax:
ras> adsl profile delete <profile>
where
This command allows you to delete an individual DSL profile by its name. You cannot delete
a profile that is assigned to any of the DSL ports in the IES-612-51A. Assign a different profile
to any DSL ports that are using the profile that you want to delete, and then you can delete the
profile.
The following example deletes the gold DSL profile.
52.1.7 DSL Port Profile Map Command
Syntax:
ras> adsl profile map <portlist> <profile>
-> <glite|gdmt|t1413|auto|adsl2|adsl2+>
where
This command assigns a specific profile to an individual port and sets the port’s operational
mode (or standard). The profile defines the maximum and minimum upstream/downstream
rates, the target upstream/downstream signal noise margins, and the maximum and minimum
upstream/downstream acceptable noise margins of all the DSL ports to which you assign the
profile.
When set to auto, the port follows whatever mode is set on the other end of the line.
Figure 217 DSL Port Profile Set Command Example 2
ras> adsl profile set goldi interleave=16,16 1200 24000 5 0 30 128 5 0 30
256 0 6 0 6
<profile> =
A profile name.
Figure 218 DSL Port Profile Delete Command Example
ras> adsl profile delete gold
<portlist> =
You can specify a single DSL port <1>, all DSL ports <*>
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
<profile> =
The profile that will define the settings of this port.
<glite|gdmt|ets
i|t1413|auto|ad
sl2|adsl2+>
=
The ADSL operational mode.