Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.8 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
Command List
address-family (BGP and BGP4+)
This command enters the IPv4 or IPv6 Address-Family Configuration command mode. In
this mode you can configure address-family specific parameters. When using VRF-Lite,
you can enter IPv4 Address Family Configuration mode for a specified VRF instance before
configuring that instance.
Syntax [BGP] address-family ipv4 [unicast]
no address-family ipv4 [unicast]
Syntax [VRF] address-family ipv4 [unicast|vrf <vrf-name>]
no address-family ipv4 [unicast|vrf <vrf-name>]
Syntax [BGP4+] address-family ipv6 [unicast]
no address-family ipv6 [unicast]
Mode [BGP]
Router Configuration or IPv4 Address Family Configuration mode for a VRF instance
Mode [BGP4+] Router Configuration
Usage [BGP/BGP4+] To leave the IPv4 or IPv6 Address Family Configuration mode, and return to the Router
Configuration mode, use the exit-address-family (BGP and BGP4+) command.
Example [BGP]
Parameter Description
ipv4
Configure parameters relating to the exchange of IPv4 prefixes.
ipv6
Configure parameters relating to the exchange of IPv6 prefixes.
unicast
Configure parameters relating to the exchange of routes to unicast
destinations.
vrf
Applies the command to the specified VRF instance.
<vrf-name>
The name of the VRF instance to enter IPv4 Address-Family mode for.
awplus#
configure terminal
awplus(config)#
router bgp 100
awplus(config-router)#
neighbor 192.168.0.1 remote-as 100
awplus(config-router)#
address-family ipv4 vrf green
awplus(config-router-af)#
neighbor 192.168.0.1 activate
awplus(config-router-af)#
exit-address-family
awplus(config-router)#