Filter
Top Products
BGP and BGP4+ Configuration
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 2.17
Router 3
Names of Commands Used
address-family (BGP and BGP4+)
aggregate-address (BGP and BGP4+)
exit-address-family (BGP and BGP4+)
neighbor remote-as (BGP and BGP4+)
network (BGP and BGP4+)
router bgp (BGP and BGP4+)
Validation Commands (re-link to BGP commands)
show ip bgp (BGP)
show ip bgp neighbors (BGP)
show ip bgp summary (BGP)
awplus(config)#
configure terminal
Enter the Global Configuration mode.
awplus(config-router)#
router bgp 200
Define the BGP routing process. The number 200
specifies the AS number of Router 3.
awplus(config-router)#
network 192.168.10.20/24
Specify the network 192.168.10.20/24 to be
advertised by the BGP4+ routing process from Router 3
to Router 2.
awplus(config-router)#
neighbor 10.10.10.30 remote-as 100
Specify the neighbor’s IPv4 address (10.10.10.30)
(and Autonomous System (AS) number (100). Router 2 is
a neighbor of Router 3.
awplus(config-router)#
address-family ipv4 unicast
Enter the IPv6 Address Family Configuration mode from
the Global Configuration mode.
awplus(config-router-af)#
neighbor 10.10.10.30 activate
Activate the exchange of information to the peer
(neighbor) with the IPv4 address 10.10.10.30 for
Router 2. Note that other information apart from prefixes
is sent in updates. This command activates the exchange
of information for the peer defined.
awplus(config-router-af)#
exit-address-family
Exit IPv4 Address Family Configuration mode, and return
to the Router Configuration mode.
awplus(config-router)#
exit
Exit the Router Configuration mode, and return to the
Global Configuration mode.