Filter
Top Products
BGP and BGP4+ Configuration
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
2.24 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
Router 2
awplus(config-router#
neighbor 2001:db8::11 remote-
as 200
Define BGP4+ neighbor Router 2, and establish a TCP session by
specifying the global unicast IPv6 address (2001:db8::11) and
the AS number (200) of neighbor Router 2.
awplus(config-router)#
address-family ipv6
Enter IPv6 Address Family Configuration mode for configuring
routing sessions that use IPv6 address prefixes.
awplus(config-router-af)#
neighbor 2001:db8::11 activate
Activate the exchange of information to the peer (neighbor)
Router 2 (2001:db8::11) and enable the exchange of IPv6
address prefix types with this neighbor. Note that other
information apart from prefixes is sent in updates. This command
activates the exchange of information for the peer defined.
awplus(config-router-af)#
exit-address-family
Exit IPv6 Address Family Configuration mode, and return to the
Router Configuration mode.
awplus(config-router)#
exit
Exit the Router Configuration mode, and return to the Global
Configuration mode.
awplus#
configure terminal
Enter the Global Configuration mode.
awplus(config)#
interface vlan1
Specify the interface (vlan1) to configure an IPv6 global
address.
awplus(config-if)#
ipv6 address 2001:db8::11/48
Specify the IPv6 global unicast address 2001:db8::10/
48 on interface vlan1.
awplus(config-if)#
exit
Leave Interface Configuration mode and enter Global
Configuration mode.
awplus(config)#
router bgp 200
Define the BGP4+ routing process. The number 200
specifies the AS number of Router 2.
awplus(config-router)#
bgp router-id 10.10.10.2
Configure a fixed Router ID (2001:db8::10) for the
BGP4+ routing process.