Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.166 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
neighbor send-community (BGP and BGP4+)
Use this command to specify that a community attribute should be sent to a BGP or
BGP4+ neighbor.
Use the no variant of this command to remove the entry for the community attribute.
Syntax [BGP/BGP4+] neighbor <neighborid> send-community {both|extended|standard}
no neighbor <neighborid> send-community {both|extended|standard}
Default [BGP/BGP4+]
Both standard and extended community attributes are sent to a neighbor.
Mode [BGP] Router Configuration or IPv4 Address Family Configuration for a VRF instance
Mode [BGP4+] Router Configuration and IPv6 Address Family Configuration
Usage [BGP/BGP4+] This command is used to specify a community attribute to be sent to a neighbor. The
community attribute groups destinations in a certain community and applies routing
decisions according to those communities. On receiving community attributes the router
reannounces them to the neighbor. Only when the no parameter is used with this
command the community attributes are not reannounced to the neighbor.
By default, both standard and extended community attributes are sent to a neighbor.
Parameter Description
<neighborid>{<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
(BGP and BGP+) command on page 3.144, and
neighbor route-map (BGP and BGP4+)
command on page 3.159. When this parameter
is used with this command, the command
applies on all peers in the specified group.
both Sends Standard and Extended Community attributes. Specifying
this parameter with the no variant of this command results in no
standard or extended community attributes being sent.
extended Sends Extended Community attributes. Specifying this parameter
with the no variant of this command results in no extended
community attributes being sent.
standard Sends Standard Community attributes. Specifying this parameter
with the no variant of this command results in no standard
community attributes being sent.