Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.38 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
bgp nexthop-trigger delay (BGP and BGP4+)
Use this command to set the delay interval for nexthop address tracking.
Use the no variant of this command to reset the timer value to the default.
Syntax [BGP/BGP4+] bgp nexthop-trigger delay <1-100>
no bgp nexthop-trigger delay
Default [BGP/BGP4+]
The default nexthop delay interval is 5 seconds.
Mode [BGP/BGP4+] Global Configuration
Usage [BGP/BGP4+] This command configures the delay interval between routing table waits for nexthop
delay tracking. The delay interval determines how long BGP waits after it receives the
trigger from the system about one or more nexthop changes before it walks the full BGP
table to determine which prefixes are affected by the nexthop changes.
Example To set the nexthop delay interval to 6 seconds, enter the command:
Related Commands bgp nexthop-trigger-count (BGP and BGP4+)
bgp nexthop-trigger enable (BGP and BGP4+)
Parameter Description
<1-100> Nexthop trigger delay interval in seconds.
awplus#
configure terminal
awplus(config)#
bgp nexthop-trigger delay 6