Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 3.19
bgp client-to-client reflection (BGP and BGP4+)
This command restores route reflection from a BGP route reflector to clients, and is used to
configure routers as route reflectors. Route reflectors are used when all Interior Border
Gateway Protocol (iBGP) speakers are not fully meshed.
If the clients are fully meshed the route reflector is not required, use the no variant of this
command to disable the client-to-client route reflection.
When a router is configured as a route reflector, client-to-client reflection is enabled by
default.
The no variant of this command turns off client-to-client reflection.
Syntax bgp client-to-client reflection
no bgp client-to-client reflection
Default
This command is enabled by default.
Mode Router Configuration
Example
Related Commands
bgp cluster-id (BGP and BGP4+)
neighbor route-reflector-client (BGP)
show bgp ipv6 (BGP4+)
show ip bgp (BGP)
awplus#
configure terminal
awplus(config)#
router bgp 100
awplus(config-router)#
no bgp client-to-client reflection