Filter
Top Products
BGP and BGP4+ Configuration
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
2.36 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
Router 1
awplus(config)#
configure terminal
Enter the Global Configuration mode.
awplus(config-router)#
router bgp 100
Define the BGP4+ routing process.
The number 100 specifies the AS number of Router 1.
awplus(config-router)#
bgp router-id 192.168.10.10
Configure a fixed Router ID (192.168.10.10) for the
BGP4+ routing process.
awplus(config-router)#
bgp graceful-restart
Enable BGP4+ graceful restart support. If the restart and
stale-path timers are not configured, the defaults are 90
seconds and 360 seconds, respectively.
awplus(config-router)#
neighbor 2001:db8::10:11 remote-as
200
Specify the neighbor’s IPv6 address (2001:db8::10:11)
and the Autonomous System (AS) number of the neighbor
(200) Router 2. Router 2 is the neighbor of Router 1.
This command defines BGP neighbor Router 2, and
establishes a TCP session by specifying the global unicast
IPv6 address and AS number of the neighbor.
awplus(config-router)#
address-family ipv6 unicast
Exchange the IPv6 capabilities, and move from Router
Configuration mode to IPv6 Address Family Configuration
mode.
awplus(config-router-af)#
neighbor 2001:db8::10:11 activate
Activate the exchange of information to the peer (neighbor)
with the IPv6 address (2001:db8::10:11) (Router 2).
Note that other information apart from prefixes is sent in
updates. This command activates the exchange of
information for the peer defined.
awplus(config-router-af)#
neighbor 2001:db8::10:11
capability graceful-restart
Specify the neighbor’s IPv6 address (2001:db8::10:11),
for which the graceful restart capability function is
supported. This command advertises the graceful restart
capability to the peer.
awplus(config-router-af)#
exit-address-family
Exit IPv6 Address Family Configuration mode, and return to
the Router Configuration mode.
awplus(config-router)#
exit
Exit the Router Configuration mode, and return to the
Global Configuration mode.