Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 3.15
bgp bestpath as-path ignore (BGP and BGP4+)
This command prevents the router from considering as-path as a factor in the algorithm
for choosing a route.
The no variant of this command allows the router to consider as-path in choosing a route.
Syntax bgp bestpath as-path ignore
no bgp bestpath as-path ignore
Mode
Router Configuration
Example
Related Commands
bgp always-compare-med (BGP and BGP4+)
bgp bestpath med (BGP and BGP4+)
bgp bestpath compare-routerid (BGP and BGP4+)
bgp bestpath compare-confed-aspath (BGP and
BGP4+)
This command specifies that the AS confederation path length must be used, when
available, in the BGP best path decision process. It is effective only when bgp bestpath as-
path ignore (BGP and BGP4+) command has not been specified.
By default, if BGP receives routes with identical eBGP paths from eBGP peers, BGP does not
continue to consider any AS confederation path length attributes that may be associated
with the routes.
The no variant of this command returns the switch to the default state, where the switch
ignores AS confederation path length in the BGP best path selection process.
Syntax bgp bestpath compare-confed-aspath
no bgp bestpath compare-confed-aspath
Mode
Router Configuration
Example
Related Commands
bgp bestpath as-path ignore (BGP and BGP4+)
awplus#
configure terminal
awplus(config)#
router bgp 100
awplus(config-router)#
bgp bestpath as-path ignore
awplus#
configure terminal
awplus(config)#
router bgp 100
awplus(config-router)#
bgp bestpath compare-confed-aspath