Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 3.197
redistribute (into BGP or BGP4+) (BGP and BGP4+)
Use this command to inject routes from one routing process into a BGP or BGP4+ routing
table.
Use the no variant of this command to disable this function.
Syntax [BGP/BGP4+] redistribute {ospf|rip|connected|static} [route-map <route-map-entry-
pointer>]
no redistribute {ospf|rip|connected|static} [route-map <route-map-
entry-pointer>]
Mode [BGP] Router Configuration or IPv4 Address Family Configuration for a VRF instance
Mode [BGP4+] Router Configuration or IPv6 Address Family Configuration
Usage [BGP/BGP4+] Redistribution is used by routing protocols to advertise routes that are learned by some
other means, such as by another routing protocol or by static routes. Since all internal
routes are dumped into BGP, careful filtering is applied to make sure that only routes to be
advertised reach the internet, not everything. This command allows redistribution by
injecting prefixes from one routing protocol into another routing protocol.
Parameter Description
connected Specifies the redistribution of connected routes
for both BGP and BGP4+.
ospf Specifies the redistribution of OSPF information
for BGP or OSPFv3 information for BGP4+.
rip Specifies the redistribution of RIP information for
BGP or RIPng information for BGP4+.
static Specifies the redistribution of Static routes for
both BGP and BGP4+.
route-map Route map reference for both BGP and BGP4+.
<route-map-entry-pointer> Pointer to route-map entries.