Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.144 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
This example removes the password set for the neighbor peer group named group1:
Related Commands neighbor peer-group (add a neighbor) (BGP and BGP+)
neighbor route-map (BGP and BGP4+)
neighbor peer-group (add a neighbor) (BGP and
BGP+)
Use this command to add a BGP or a BGP4+ neighbor to an existing peer-group.
Use the no variant of this command to disable this function.
Syntax [BGP] neighbor <ip-address> peer-group <peer-group>
no neighbor <ip-address> peer-group <peer-group>
Syntax [BGP4+] neighbor <ipv6-addr> peer-group <peer-group>
no neighbor <ipv6-addr> peer-group <peer-group>
Mode [BGP] Router Configuration or IPv4 Address Family Configuration for a VRF instance
Mode [BGP4+] IPv6 Address Family Configuration
Usage [BGP/BGP4+] Use this command to add neighbors with the same update policies to a peer group. This
facilitates the updates of various policies, such as, distribute and filter lists. The peer-group
is then configured easily with many of the neighbor commands. Any changes made to the
peer group affect all members.
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
no neighbor group1 password
Parameter Description
<ip-address> Specify the IPv4 address of the BGP neighbor, entered in the format
A.B.C.D.
<ipv6-addr> Specify the IPv6 address of the BGP4+ neighbor, entered in
hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of the peer-group. When this parameter is used
with this command, the command applies on all peers in the
specified group.