Filter
Top Products
BGP and BGP4+ Configuration
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
2.28 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
Names of Commands Used
address-family (BGP and BGP4+)
bgp router-id (BGP and BGP4+)
exit-address-family (BGP and BGP4+)
neighbor activate (BGP and BGP4+)
neighbor remote-as (BGP and BGP4+)
router bgp (BGP and BGP4+)
Validation Commands
show bgp ipv6 (BGP4+)
show bgp ipv6 neighbors (BGP4+)
show bgp ipv6 summary (BGP4+)
awplus(config-router#
neighbor fe80::1 interface vlan2
Specify a link-local neighbor, and configure the interface
name of the neighbor (fe80::1).
awplus(config-router)#
address-family ipv6
Enter IPv6 Address Family Configuration mode for
configuring routing sessions that use IPv6 address
prefixes.
awplus(config-router-af)#
neighbor fe80::1 activate
Activate the exchange of information to the peer
(neighbor) Router 1 (fe80::1) and enable the exchange
of IPv6 address prefix types with this neighbor. Note that
other information apart from prefixes is sent in updates.
This command activates the exchange of information for
the peer defined.
awplus(config-router-af)#
exit-address-family
Exit IPv6 Address Family Configuration mode, and return
to the Router Configuration mode.
awplus(config-router)#
exit
Exit the Router Configuration mode, and return to the
Global Configuration mode.