Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 3.57
clear bgp ipv6 (ipv6 address) (BGP4+)
Use this command to reset the IPv6 BGP4+ connection to the peer specified by the IP
address.
Syntax clear bgp ipv6 <ipv6-addr> [in [prefix-filter]|out|soft [in|out]]
Mode
Privileged Exec
Examples Use the following command to clear the BGP4+ connection to peer at IPv6 address
2001:0db8:010d::1, and clearing all incoming routes.
Parameter Description
<ipv6-addr> Specifies the IPv6 address of the neighbor whose connection is to
be reset, entered in hexadecimal in the format X:X::X:X.
ipv6 Clears all IPv6 address family peers. Configure parameters relating
to the BGP4+ exchange of IPv6 prefixes.
in Indicates that incoming advertised routes will be cleared.
prefix-filter Specifies that a prefix-list will be sent, by the ORF mechanism, to
those neighbors with which the ORF capability has been
negotiated. The neighbors will be triggered to resend updates,
which match the prefix-list filter, to the local router. The local
router will then perform a soft reconfiguration.
out Indicates that outgoing advertised routes will be cleared.
soft in Soft inbound reset causes the neighbors to resend all their
updates to the local switch, without resetting the connection or
clearing the entries in the local switch. So, the local switch stores
new updates, and uses them to systematically replace existing
table entries. This process can use a considerable amount of
memory.
soft out Soft outbound reset causes the switch to simply resend all its
updates to the specified neighbor(s), without resetting the
connection, or clearing table entries.
awplus#
clear ip bgp 2001:0db8:010d::1 in