Filter
Top Products
BGP and BGP4+ Configuration
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
2.16 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
Router 2
awplus(config)#
configure terminal
Enter the Global Configuration mode.
awplus(config-router)#
router bgp 100
Define the BGP routing process. The number 100
specifies the AS number of Router 2.
awplus(config-router)#
neighbor 10.10.10.40 remote-as 200
Specify the neighbor’s IPv4 address (10.10.10.40) and
Autonomous System (AS) number (200). Router 3 is a
neighbor of Router 2.
awplus(config-router)#
neighbor 10.10.10.10 remote-as 100
Specify the neighbor’s IPv4 address (10.10.10.10)
(and Autonomous System (AS) number (100). Router 1 is
a neighbor of Router 2.
awplus(config-router)#
address-family ipv4 unicast
Enter the IPv4 Address Family Configuration mode from
the Global Configuration mode.
awplus(config-router-af)#
aggregate-address 172.31.10.10/24
summary-only
Configure an IPv4 non-AS-set aggregate route on Router
2. Note that the local distance gets applied to this route.
awplus(config-router-af)#
neighbor 10.10.10.10 activate
Activate the exchange of information to the peer
(neighbor) with the IPv4 address 10.10.10.10 (Router
1). Note that other information apart from prefixes is sent
in updates. This command activates the exchange of
information for the peer defined.
awplus(config-router-af)#
neighbor 10.10.10.40 activate
Activate the exchange of information to the peer
(neighbor) with the IPv4 address 10.10.10.40 (Router
3). Note that other information apart from prefixes is sent
in updates. This command activates the exchange of
information for the peer defined.
awplus(config-router-af)#
distance 12 13 11
Configure the administrative distance for external,
internal, and local routes received in IPv6 Address Family
Configuration mode.
awplus(config-router-af)#
exit-address-family
Exit IPv4 Address Family Configuration mode, and return
to the Router Configuration mode.
awplus(config-router)#
exit
Exit the Router Configuration mode, and return to the
Global Configuration mode.