Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 3.147
neighbor port (BGP and BGP4+)
Use this command to specify the TCP port to which packets are sent to on a BGP or a
BGP4+ neighbor. TCP port 179 is the default port used to connect BGP and BGP4+ peers.
You can specify a different destination port for the TCP session with this command.
Use the no variant of this command to reset the port number back to the default value
(TCP port 179).
Syntax [BGP] neighbor <neighborid> port <portnum>
no neighbor <neighborid> port [<portnum>]
Default
TCP port 179 is the default port used to connect BGP and BGP4+ peers.
Mode [BGP] Router Configuration or IPv4 Address Family Configuration for a VRF instance
Mode [BGP4+] Router Configuration
Examples [BGP]
Parameter Description
<neighborid> {<ip-address>|ipv6-addr>|<peer-group>}
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+
neighbor, entered in hexadecimal in the
format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) (BGP and BGP+) command on
page 3.144, and neighbor route-map (BGP
and BGP4+) command on page 3.159. When
this parameter is used with this command, the
command applies on all peers in the specified
group.
<portnum> <0-65535> Specifies the TCP port number.
awplus#
configure terminal
awplus(config)#
router bgp 12
awplus(config-router)#
neighbor 10.10.10.10 port 643
awplus#
configure terminal
awplus(config)#
router bgp 12
awplus(config-router)#
no neighbor 10.10.10.10 port 643