Filter
Top Products
BGP and BGP4+ Configuration
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
2.40 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
Router 2
awplus(config-router)#
neighbor 2001:db8::120 remote-as
100
Specify the neighbor’s IPv6 address (2001:db::120)
and Autonomous System (AS) number (100). Router 2 is
the neighbor of Router 1. This command defines BGP
neighbor Router 2, and establishes a TCP session by
specifying the global unicast IPv6 address and the AS
number of the neighbor.
awplus(config-router)#
address-family ipv6 unicast
Enter the IPv6 Address Family Configuration mode from
the Global Configuration mode.
awplus(config-router-af)#
neighbor 2001:db8::120 activate
Activate the exchange of information to the peer
(neighbor) with the global unicast IPv6 address
2001:db::120 for Router 2. Note that other
information apart from prefixes is sent in updates. This
command activates the exchange of information for the
peer defined.
awplus(config-router-af)#
exit-address-family
Exit IPv6 Address Family Configuration mode, and return
to the Router Configuration mode.
awplus(config-router)#
exit
Exit the Router Configuration mode, and return to the
Global Configuration mode.
awplus(config)#
configure terminal
Enter the Global Configuration mode.
awplus(config-router)#
router bgp 100
Define the BGP4+ routing process. The number 100
specifies the AS number of Router 2.
awplus(config-router)#
neighbor 2001:db8::121 remote-as
100
Specify the neighbor’s global unicast IPv6 address
(2001:db8::121) and Autonomous System (AS)
number (100). Router 1 is a neighbor of Router 2. This
command defines BGP4+ neighbor Router 1, and
establishes a TCP session by specifying the global unicast
IPv6 address and the AS number of the neighbor.
awplus(config-router)#
neighbor 2001:db8::115 remote-as
200
Specify the neighbor’s global unicast IPv6 address
(2001:db8::115) (and Autonomous System (AS)
number (200). Router 3 is a neighbor of Router 2. This
command defines BGP4+ neighbor Router 3, and
establishes a TCP session by specifying the global unicast
IPv6 address and the AS number of the neighbor.
awplus(config-router)#
address-family ipv6 unicast
Enter the IPv6 Address Family Configuration mode from
the Global Configuration mode.