Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.110 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
neighbor description (BGP and BGP4+)
Use this command to associate a description with a BGP or a BGP4+ neighbor. We
recommend adding descriptions to defined neighbors, so any network administrators or
network engineers can see a description of connected BGP or BGP4+ peers on the switch.
Use the no variant of this command to remove the description from a BGP or a BGP4+
neighbor.
Syntax neighbor <neighborid> description <description>
no neighbor <neighborid> description [<description>]
Mode [BGP]
Router Configuration or IPv4 Address Family Configuration for a VRF instance
Mode [BGP4+] Router Configuration
Examples [BGP]
Parameter Description
<neighborid> {<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address>
Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+
neighbor, entered in hexadecimal in the
format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) (BGP and BGP+) command on
page 3.144, and neighbor route-map (BGP
and BGP4+) command on page 3.159. When
this parameter is used with this command, the
command applies on all peers in the specified
group.
<description> Enter up to 80 characters of text describing the neighbor.
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
neighbor 10.10.10.1 description Backup
router for sales
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
no neighbor 10.10.10.1 description