Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.134 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
neighbor next-hop-self (BGP and BGP4+)
Use this command to configure the BGP or BGP4+ router as the next hop for a BGP or
BGP4+ speaking neighbor or peer group.
Use the no variant of this command to disable this feature.
Syntax [BGP/BGP4+] neighbor <neighborid> next-hop-self
no neighbor <neighborid> next-hop-self
Mode [BGP]
Router Configuration or IPv4 Address Family Configuration for a VRF instance
Mode [BGP4+] IPv6 Address Family Configuration
Usage [BGP/BGP4+] This command allows a BGP or BGP4+ router to change the nexthop information that is
sent to the iBGP peer. The nexthop information is set to the IP address of the interface
used to communicate with the neighbor.
This command can be run for a specific VRF instance.
Examples [BGP]
Parameter Description
<neighborid>{<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
(BGP and BGP+) command on page 3.144, and
neighbor route-map (BGP and BGP4+)
command on page 3.159. When this parameter
is used with this command, the command
applies on all peers in the specified group.
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
neighbor 10.10.0.72 next-hop-self
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
no neighbor 10.10.0.72 next-hop-self