Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.102 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
neighbor capability route-refresh (BGP and BGP4+)
Use this command to advertise route-refresh capability to the specified BGP and BGP4+
neighbors.
Use the no variant of this command to disable this function
Syntax [BGP/BGP4+] neighbor <neighborid> capability route-refresh
no neighbor <neighborid> capability route-refresh
Mode [BGP/BGP4+]
Router Configuration
Default [BGP/BGP4+] Enabled
Usage [BGP/BGP4+] Use this command to advertise to peer about route refresh capability support. If route
refresh capability is supported, then router can dynamically request that the peer
readvertises its Adj-RIB-Out.
Parameter Description
<neighborid>{<ip-address>|ipv6-addr>|<peer-group>}
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
(BGP and BGP+) command on page 3.144, and
neighbor route-map (BGP and BGP4+)
command on page 3.159. When this parameter
is used with this command, the command
applies on all peers in the specified group.