Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.156 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
Related Commands show ip bgp (BGP)
neighbor restart-time (BGP and BGP4+)
Use this command to set a different restart-time other than the global restart-time
configured using the bgp graceful-restart command for BGP and BGP4+.
Use the no variant of this command to restore the device to its default state (see the
default value of the bgp graceful-restart command).
Syntax [BGP/BGP4+] neighbor <neighborid> restart-time <delay-value>
no neighbor <neighborid> restart-time <delay-value>
Mode [BGP]
Router Configuration or IPv4 Address Family Configuration for a VRF instance
Mode [BGP4+] Router Configuration
Usage [BGP/BGP4+] This command takes precedence over the restart-time value specified using the bgp
graceful-restart command.
The restart-time value is the maximum time that a graceful-restart neighbor waits to come
back up after a restart. The default is 120 seconds.
Make sure that the restart time specified using this command does not exceed the
stalepath-time specified in the Router Configuration mode.
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
no neighbor 10.10.0.63 remove-private-AS
Parameter Description
<neighborid>{<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) (BGP and BGP+) command on
page 3.144, and neighbor route-map (BGP
and BGP4+) command on page 3.159. When
this parameter is used with this command, the
command applies on all peers in the specified
group.
<delay-value> <1-3600>Delay value in seconds.