Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 3.165
neighbor route-server-client (BGP)
Use this command to specify the peer as route server client.
Use the no variant of this command to disable this function.
Syntax neighbor <neighborid> route-server-client
no neighbor <neighborid> route-server-client
Mode
Router Configuration
Examples
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
no neighbor 10.10.0.72
route-reflector-client
Parameter Description
<neighborid>{<ip-address>|<peer-group>}
<ip-address> The address of an IPv4 BGP neighbor, in dotted
decimal notation A.B.C.D.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) (BGP and BGP+) command on
page 3.144, and neighbor route-map (BGP
and BGP4+) command on page 3.159. When
this parameter is used with this command, the
command applies on all peers in the specified
group.
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
neighbor 10.10.0.72 route-server-client
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
no neighbor 10.10.0.72
route-server-client