Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 3.119
Related Commands neighbor peer-group (add a neighbor) (BGP and BGP+)
neighbor route-map (BGP and BGP4+)
neighbor ebgp-multihop (BGP and BGP4+)
Use this command to accept and attempt BGP or BGP4+ connections to external peers on
indirectly connected networks.
Effectively, this command sets the TTL value in the BGP or BGP4+ packets that the router
sends to the neighbor, so that the packets may traverse the network route to the
neighbor.
The switch will not establish a connection to a multihop neighbor, if the only route to the
multihop peer is a default route.
Use the no variant of this command to return to the default.
Syntax [BGP/BGP4+] neighbor <neighborid> ebgp-multihop [<count>]
no neighbor <neighborid> ebgp-multihop [<count>]
Mode [BGP] Router Configuration or IPv4 Address Family Configuration for a VRF instance
Mode [BGP4+] Router Configuration
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
no neighbor group1
dont-capability-negotiate
Parameter Description
<neighborid>{<ip-address|ipv6-addr|<peer-group>}
<ip-addr> Specify the address of an IPv4 BGP neighbor,
entered in dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
(BGP and BGP+) command on page 3.144, and
neighbor route-map (BGP and BGP4+)
command on page 3.159. When this parameter
is used with this command, the command
applies on all peers in the specified group.
<count> <1-255> The Maximum hop count, that is set in the TTL field of the
BGP packets. If this optional parameter is not specified with the
command, then the Maximum hop count is set to 255.