Filter
Top Products
BGP and BGP4+ Configuration
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
2.32 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
awplus(config-router-map)#
exit
Exit the Route-map Configuration mode and return to the
Global Configuration mode.
awplus(config)#
router bgp 10
Define the routing process, where 10 is the Autonomous
System (AS) number for Router 1.
awplus(config-router)#
bgp router-id 192.168.10.10
Configure a fixed Router ID (192.168.10.10) for the BGP4+
routing process.
awplus(config-router#
neighbor 2001:db8::10:11
remote-as 11
Define BGP neighbor Router 2, and establish a TCP session by
specifying the global unicast IPv6 address
(2001:db8::10:11) and the AS number (11) of neighbor
Router 2.
awplus(config-router)#
address-family ipv6
Enter IPv6 Address Family Configuration mode for configuring
routing sessions that use IPv6 address prefixes.
awplus(config-router-af)#
neighbor 2001:db8::10:11
route-map list1 in
Apply the route-map list1 to all incoming routes.
awplus(config-router-af)#
neighbor 2001:db8::10:11
activate
Activate the neighbor Router 2 (2001:db8::10:11), and
enable the exchange of IPv6 address prefix types with this
neighbor. Note that other information apart from prefixes is
sent in updates. This command activates the exchange of
information for the peer defined.
awplus(config-router-af)#
exit-address-family
Exit IPv6 Address Family Configuration mode, and return to
the Router Configuration mode.
awplus(config-router)#
exit
Exit the Router Configuration mode, and return to the Global
Configuration mode.