Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.198 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
Examples
[BGP/BGP+]
The following example shows the configuration of a route-map named rmap1, which is
then applied using the redistribute route-map command.
To apply the above example to a specific VRF instance named blue, use the following
commands:
The following example shows the configuration of a route-map named rmap2, which is
then applied using the redistribute route-map command.
Note that configuring a route-map and applying it with the redistribute route-map
command allows you to filter which router are distributed from another routing protocol
(such as OSPF with BGP). A route-map can also set the metric, tag, and metric-type of the
redistributed routes.
awplus#
configure terminal
awplus(config)#
route-map rmap1 permit 1
awplus(config-route-map)#
match origin incomplete
awplus(config-route-map)#
set metric 100
awplus(config-route-map)#
exit
awplus(config)#
router bgp 12
awplus(config-router)#
redistribute ospf route-map rmap1
awplus(config)#
router bgp 12
awplus(config-router)#
address-family ipv4 vrf blue
awplus(config-router-af)#
redistribute ospf route-map rmap1
awplus#
configure terminal
awplus(config)#
route-map rmap2 permit 3
awplus(config-route-map)#
match interface vlan1
awplus(config-route-map)#
set metric-type 1
awplus(config-route-map)#
exit
awplus(config)#
router ospf 100
awplus(config-router)#
redistribute bgp route-map rmap2