Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.36 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
bgp memory maxallocation (BGP and BGP4+)
This command allocates a maximum percentage of the RAM (Random Access Memory)
available on the switch for BGP processes.
When this percentage is exceeded, BGP peering terminates and an out of resources error
displays. The default setting for bgp memory maxallocation is 100% memory allocation.
Use the no variant of this command to reset memory allocation to the default.
Syntax [BGP/BGP4+] bgp memory maxallocation <1-100>
no bgp memory maxallocation
Default [BGP/BGP4+]
BGP processes are allocated the maximum percentage of 100% of the switch’s available
RAM memory by default. Note only non-default BGP memory allocation values are shown
in the running or startup configuration files:
Mode [BGP/BGP4+] Global Configuration
Examples
[BGP/BGP4+]
To limit the maximum amount of memory used by BGP processes to 65% of the total RAM
memory available on the switch, use the commands:
To return to the default 100% maximum RAM memory allocation available on the switch
for BGP processes, use the commands:
Parameter Description
<1-100> Percentage of switch memory allocated to BGP processes.
Note this is RAM (Random Access Memory), not switch flash
memory.
awplus#show running-config
!
bgp memory maxallocation 50
!
awplus#
configure terminal
awplus(config)#
bgp memory maxallocation 65
awplus#
configure terminal
awplus(config)#
no bgp memory maxallocation