Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.112 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
Related Commands neighbor peer-group (add a neighbor) (BGP and BGP+)
neighbor route-map (BGP and BGP4+)
neighbor disallow-infinite-holdtime (BGP and
BGP4+)
Use this command to disallow the configuration of infinite holdtime for BGP and BGP4+.
Use the no variant of this command to allow the configuration of infinite holdtime for BGP
or BGP4+.
Syntax [BGP] neighbor {<ip-address>} disallow-infinite-holdtime
no neighbor {<ip-address>} disallow-infinite-holdtime
Syntax [BGP4+] neighbor {<ipv6-addr>} disallow-infinite-holdtime
no neighbor {<ipv6-addr>} disallow-infinite-holdtime
Mode [BGP/BGP4+]
Router Configuration
Usage [BGP/BGP4+] This command enables the local BGP or BGP4+ speaker to reject holdtime “0” seconds
from the peer during exchange of open messages or the user during configuration.
The no variant of this command allows the BGP speaker to accept “0” holdtime from the
peer or during configuration.
Examples [BGP] To enable the disallow-infinite-holdtime feature on the BGP speaker with the IP address
of 10.10.10.1, enter the command:
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
no neighbor group1 description Backup
router for sales
Parameter Description
<ip-address> Specify the address of an IPv4 BGP neighbor, in dotted decimal
notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor, entered in
hexadecimal in the format X:X::X:X.
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
neighbor 10.10.10.1 disallow-infinite-
holdtime