Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.114 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
neighbor distribute-list (BGP and BGP4+)
This command filters route updates from a particular BGP or BGP4+ neighbor using an
access control list.
You can add one incoming and one outgoing distribute-list for each BGP or BGP4+
neighbor.
The no variant of this command removes a previously configured BGP or BGP4+
distribute-list.
Syntax [BGP/BGP4+] neighbor <neighborid> distribute-list <access-list> {in|out}
no neighbor <neighborid> distribute-list <access-list> {in|out}
Mode [BGP]
Router Configuration or IPv4 Address Family Configuration for a VRF instance
Mode [BGP4+] IPv6 Address Family Configuration
Examples [BGP]
Parameter Description
<neighborid>
Specify an identification method for the BGP or BGP4+ peer. Use
one of the following formats:
<ip-address>
Specify the address of an IPv4 BGP neighbor,
in dotted decimal notation
A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+
neighbor, entered in hexadecimal in the
format X:X::X:X.
<peer-group>
Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) (BGP and BGP+) and neighbor
route-map (BGP and BGP4+) commands.
When this parameter is used with this
command, the command applies on all peers in
the specified group.
<access-list>
The specific access-list used to filter routes. Specify one of the
following types of access-lists:
<WORD>
The name of IP access-list.
<1-199>
The ID number of a standard IP access-list.
<1300-2699>
The ID number of an extended IP access-list.
in
Indicates that incoming advertised routes will be filtered.
out
Indicates that outgoing advertised routes will be filtered.
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
neighbor 10.10.10.1 distribute-list
mylist out