Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.202 AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 C613-50032-01 REV D
If it does not find a match, it discards the route or update message. This means that route
maps end with an implicit deny entry. To permit all non-matching routes or update
messages, end your route map with an entry that has an action of permit and no match
clause.
Examples To enter route-map mode for entry 1 of the route map called route1, and then add a
match and set clause to it, use the commands:
To enter route-map mode for entry 2 of the route map called route1, and then add a
match and set clause to it, use the commands:
Note how the prompt changes when you go into route map configuration mode.
To make the device process non-matching routes instead of discarding them, add a
command like the following one:
Related Commands bgp dampening (BGP)
neighbor default-originate (BGP)
neighbor route-map (BGP)
neighbor unsuppress-map (BGP)
network (BGP)
redistribute (into BGP) (BGP)
show ip bgp route-map (BGP)
show route-map (Route Map)
awplus#
configure terminal
awplus(config)#
route-map route1 permit 1
awplus(config-route-map)#
match as-path 60
awplus(config-route-map)#
set weight 70
awplus#
configure terminal
awplus(config)#
route-map route1 permit 2
awplus(config-route-map)#
match interface vlan2
awplus(config-route-map)#
set metric 20
awplus(config)#
route-map route1 permit 100