Filter
Top Products
Maintenance
132 Avaya CMS Sun Ultra 5 Computer Hardware Installation, Maintenance, and Troubleshooting
Removing and replacing the CD-ROM drive
To remove and replace the CD-ROM drive:
1. Loosen, but do not remove the three screws that secure the diskette drive or hard drive
mounting bracket to the top of the chassis frame. See the following figure.
2. Remove the drive bracket from the chassis by sliding it back and lifting it free of the
three screws.
3. Set the drive bracket on top of the power supply.
4. Disconnect the following cables from the back of the CD-ROM drive:
● Audio cable
● CD-ROM data ribbon cable
● Power cable.
5. Remove the four screws that hold the CD-ROM drive in the CD-ROM drive bracket.
6. Push the CD-ROM drive toward the chassis front and remove.
7. Place the CD-ROM drive on an antistatic mat.
8. On the new CD-ROM drive, verify that the jumper is set to the Master (MA) position.
9. Slide the new CD-ROM drive into the CD-ROM drive bracket.
10. Attach the CD-ROM drive to the CD-ROM drive bracket using the four screws that
were removed earlier.
u5_cdrom_cables.cdr