Avaya 585-215-871 Network Hardware User Manual


 
Maintaining disk drives
Issue 3.3 February 2003 99
Installing the secondary disk drive
To install the new secondary internal disk drive:
1. Ensure that the jumpers on the secondary internal hard drive are set to the Cable
Select (CS) setting. See the following figure.
2. Attach the secondary internal disk drive to the new mounting bracket with the four
screws from the old disk drive or from the new disk drive kit. Arrange the drive so that
the connectors point to the back of the computer.
Tip:
Tip : Install each screw with just a few turns before you tighten all four screws.
3. Connect the EIDE ribbon cable connector labeled SLAVE to the secondary internal
disk drive.
EIDE ribbon
cable connector
Jumper in
Cable Select (CS)
position
Power
connector
cable_sel.cdr
Screw (4)
Secondary
disk drive
Screw (3)
u5_second_disk.cdr