Avaya 585-215-871 Network Hardware User Manual


 
Maintenance
92 Avaya CMS Sun Ultra 5 Computer Hardware Installation, Maintenance, and Troubleshooting
Turning on the system
To turn on the system:
1. Turn on all external SCSI devices starting with the device that is farthest from the
system and working toward the system.
2. Turn on the system monitor.
3. Turn on the system.
4. Press Stop+A simultaneously after the console banner is displayed, but before the
system starts booting.
5. Enter the following commands:
setenv auto-boot? false
reset-all
This resets the system and the ok prompt is displayed.
6. Enter:
probe-ide
This checks to see that the system recognizes the new disk drive. If the new drive is
not listed, check for a secure connection between the motherboard and the new drive.
7. Reboot the system by entering the following commands:
!
CAUTION:
CAUTION: If you fail to enter these commands, any reboots that you do in the future will
stop at the boot prompt instead of proceeding through the normal boot-up
process.
setenv auto-boot? true
boot -r
8. Continue with Setting up the disk drives
on page 110.