Filter
Top Products
Maintaining disk drives
Issue 3.3 February 2003 89
Installing the new primary internal disk drive
To install the new primary internal disk drive:
1. Ensure that the jumpers on the primary internal hard drive are set to the Cable Select
(CS) setting. See the following figure.
2. Using the original mounting bracket, attach the new primary disk drive labeled “Master
Disk” to the mounting bracket using the four screws from the new disk drive kit. The
mounting bracket that came with the new primary disk drive can be discarded.
Tip:
Tip : Install each screw with just a few turns before you tighten all four screws.
3. With the new primary internal disk drive you will receive new EIDE ribbon cables. Use
the cable that has three connectors (SLAVE, MASTER, and MOTHERBOARD).
Connect the end labeled MASTER to the connector on the rear of the new primary
internal disk drive.
4. Connect the power cable to the primary internal disk drive.
EIDE ribbon
cable connector
Jumper in
Cable Select (CS)
position
Power
connector
cable_sel.cdr
u5_master_install.cdr