Filter
Top Products
Maintaining tape drives
Issue 3.3 February 2003 143
SCSI devices are addressed as shown in the following table.
These addresses are set using the target address switches on the back of each SCSI
device. Before setting the target address, make sure that the power is off on the SCSI
devices.
Continue with Turning on t
he system on page 144.
Device Address
Disk drive 1 0
Disk drive 2 1
Disk drive 3 2
Disk drive 4 3
Tape drive 1 4
Tape drive 2 5
!
Important:
!
Important:
Important: Do not use a target address
greater than 5.
Press this side to increase
the address number.
Press this side to decrease
the address number.
+
2
scsiidsw.cdr